Boot up MS-DOS and enter the DEBUG program. Type the
following commands:
The following commands will clear CMOS:
-o 70 2e <CR>
-o 71 ff <CR>
-o 70 2f <CR>
-o 71 ff <CR>
The following commands will clear EISA NVRAM:
-o 800 ff <CR>
-o 808 ff <CR>
-o 810 ff <CR>
-o 880 ff <CR>
This will reset the system and require that the CMOS Setup and ECU be
run. It may be necessary to reboot the computer a couple of times to
correct any CMOS and ECU errors.
